ASRCM
  Welcome to ASRCM's Forum!
Welcome, Guest. Please Login or Register
  HomeHelpSearchLoginRegister Windy Weather Milford 102 Cam  
 
Page Index Toggle Pages: 1
Send Topic Print
Carbon Cub - motor wiring (Read 3322 times)
speedbird
Junior Member
**
Offline


ASRCM Forum member!

Posts: 98
Edmonton
Carbon Cub - motor wiring
Apr 13th, 2015 at 9:31pm
 
anyone figured out how to stow the foot of wire which blocks air flow, without cutting both the ECS leads and the motor leads, the 9 o/c position does not cut it.

pic sideways iphone  Undecided
Back to top
 

carbon_cub_2.jpeg (381 KB | 372 )
carbon_cub_2.jpeg

Brian
 
IP Logged
 
speedbird
Junior Member
**
Offline


ASRCM Forum member!

Posts: 98
Edmonton
Re: Carbon Cub - motor wiring
Reply #1 - May 1st, 2015 at 1:56pm
 
After my 60 amp CC ESC fried itself, horizon hobby replaced my 60 amp ESC.
Now I am thinking ... New Transmitter (Futaba 8) new ESC
>>somewhere i read about throttle being reversed first time in the setup and the ESC going into programming mode.
Now not being use to Elite ESCs, i wonder what they do with 6S battery if they are programmed out of the shipped auto setting by ignorance/mistake, say into the 3S mode.

would that cause them to roast themselves?
Back to top
 

Brian
 
IP Logged
 
FLC astroflyer
Private
****
Offline


MULLIGAN driver

Posts: 6524
Milford, N.S.
Re: Carbon Cub - motor wiring
Reply #2 - May 1st, 2015 at 3:55pm
 
cannot say for sure brian, but if an esc is rated for six cells, I can't see programming burning it out.  six cell components would still be six cell components.

however, reversed polarity on the battery leads sure would.  check your polarity carefully before plugging in the new one.

and yes, with futaba, you always have to reverse the throttle srtting.
Back to top
 

OLDEST AL the walking spellchecker
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print